How to install Grip YOU

Quick Installation...See Video below

1. GripYOU Arrangement

Select your preferred combination of rings and end-cap. Any mix and placement of components is fine - customize and experiment to determine what is best for you. A common implementation is to install the end-cap with one ring.

2. Grip-Ring™

Slide the elastic ring over the grip and into comfortable position. A good starting position is approximately 3 inches from the end of the racquet such that your index finger has leverage over the ring as a 'trigger'. Add more rings if preferred.

3. End-Cap

First, ensure the grip surface is clean. Slip the end-cap over one side of the grip and hold that end in position with your thumb. With your other hand index finger, pull the center of cap over entire butt of your racquet. Once the end-cap lip is around the grip, mold into position so bottom of cap is flush with the racquet butt.

4. Over-Grip Wrap

Ensure the end-cap outer surface is clean. Wrap the over-grip as you normally install. Wrap snugly with slight over-lap over the Grip-Ring™. Test the feel of your overall arrangement... then grip and rip!